Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Mercury Mountaineer 1997-2010. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Mercury Mountaineer 1997-2010 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2010 ENGINE Exhaust System - Explorer, Explorer Sport Trac & Mountaineer
This pinpoint test is intended to diagnose the following:
Exhaust system
PINPOINT TEST A: DRUMMING NOISE
A1 CHECK THE EXHAUST SYSTEM
Start the engine.
Increase the engine rpm until the noise is the loudest. Note the engine rpm.
Ignition OFF.
Add approximately 9 kg (20 lb) of weight to the exhaust system. First place the weight at the tail pipe and test, then at the front pipe.
Start the engine.
Increase the engine rpm and listen for the drumming noise. Note the engine rpm if the noise occurs.
Ignition OFF.
Determine the amount of vibration that occurs with the drumming noise.
Is the noise/vibration reduced or eliminated, or does the noise/vibration occur at a different rpm?
Yes: REFER to EXHAUST SYSTEM ALIGNMENT. TEST the system for normal operation.
No: CONDUCT a diagnosis on other suspect systems. REFER to NOISE, VIBRATION & HARSHNESS.
GENERAL PROCEDURES
EXHAUST SYSTEM ALIGNMENT
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING.
NOTE: Do not use oil or grease-based lubricants on the isolators. These lubricants may cause deterioration of the rubber. This can lead to separation of the isolator from the exhaust hanger bracket during vehicle operation. Use only water-based lubricants on the isolators.
NOTE: Exhaust fasteners are of a prevailing torque design. Use only new fasteners with the same part number as the original. Torque values must be used as specified during reassembly to make sure of correct retention of exhaust components.
NOTE: Always install new gasket and nuts whenever an exhaust joint is loosened.
...