Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Mitsubishi Outlander 2001-2006. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Mitsubishi Outlander 2001-2006 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
AUTOMATIC AIR CONDITIONER - TROUBLESHOOTING
DIAGNOSIS
Step 1. Use the MUT-II/III to confirm a diagnosis code. On completion, check that the diagnosis code is not reset.
Q: Is the check result normal?
YES : Go to Step 2.
NO : Refer to diagnosis code chart P.55B-4.
Step 2. Check the blower operation.
(1) Turn the ignition switch to the ON position.
(2) Blower knob: Other than OFF
(3) Check that the air comes out of the blower.
Q: Is the check result normal?
YES : Go to Step 3.
NO : Refer to Inspection Procedure 4 "The blower does not work."
STEP 3. Check the defogger and outside/inside air selection damper control motor operation.
Q: Do the defogger and outside/inside air selection damper control motor work normally?
YES : Go to Step 4.
NO : Refer to Inspection procedure 10
"Malfunction of the A/C-ECU power supply system P.55B-88."
STEP 4. Check the A/C compressor.
Check the A/C compressor for compressor oil leaks.
Q: Is the check result satisfactory?
YES : Go to Step 5.
NO : Replace the A/C compressor or the expansion valve.
STEP 5. Measure the voltage at B-27 A/C compressor connector.
(1) Disconnect the connector, and measure at the wiring harness side.
(2) Turn the ignition switch to the "ON" position.
(3) Disconnect engine-ECU connector C-139 and earth terminal 8.
(4) Voltage between terminal 1 and body earth.
OK: System voltage
Q: Is the check result normal?
YES : Go to Step 17.
NO : Go to Step 6.
STEP 6. Check the A/C compressor relay continuity.
Refer to GROUP 55A - On vehicle service, power relay P.55A-57.
Q: Is the A/C compressor relay in good condition?
YES : Go to Step 7.
AC301648 NO : Replace the A/C compressor relay.
Connector: B-27
...