Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Bobcat 337, 341, 463, 753, 7753, E35, S130 Loader / Excavator. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your equipment like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

MAKE: Bobcat
--- --- --- --- --- --- --- --- ---
MODEL: 337, 341, 463, 753, 7753, E35, S130
--- --- --- --- --- --- --- --- ---
FORMAT: PDF (274 MB)

Service Manual + Part Manual + Operator's Manual + Electrical Schematics

EXCERPT:
5 MAIN FRAME
OPERATOR CAB GAS CYLINDER
Removal and Installation
Cylinder contains high pressure gas. Do not open. Opening cylinder can release rod and cause injury or death.
Remove the operator cab stop (both sides) [A].
Raise the operator cab (Page 1–5).
Connect a chain to the operator cab and lift arm link [B].
Remove the bolts from the bracket which mounts to the loader fender; Right Side [C] or Left Side [D].
Slide the mounting bracket forward to release the tension on the gas cylinder [A].
Installation: Move the mounting bracket toward the holes in the fender, use a punch to align the holes in the mounting bracket with the holes in the fender.
Remove the cotter pin from the top pivot pin [B].
Remove the pivot pin [C].
Remove the bushing and gas cylinder [D].
Repeat the procedure to remove the other gas cylinder.
Disassembly and Assembly
Remove the clevis (Item 1) and washer (Item 2) from the end of the gas cylinder [A].
Remove the gas cylinder from the outer housing.
Installation: Install a replacement cylinder inside the cylinder housing.
Apply a small amount of Loc–Tite on the threads of the cylinder rod [B].
Re–Install the washer and clevis on the cylinder rod.
OPERATOR CAB
Removal and Installation
Remove the gas cylinders (Page 5–1).
Disconnect the electrical wiring harness connectors [C].
NOTE: Two people will be needed to lower the cab because the gas cylinders are disconnected.
Lower the operator cab.
Connect a chain hoist to the operator cab as shown in figure [D].
Remove the nut from the pivot bolt (both sides) [A].
Installation: Tighten the pivot bolt and nut to 25–35 ft.–lbs. (34–47 Nm) torque.
Use a punch and hammer to remove the pivot bolt (both sides) [B].
Lift the operator cab and remove it from the loader frame.
REAR DOOR
Removal and Installation
Connect a chain hoist to the rear door [C].
Remove the pivot bolt and nut (both top and bottom) [D].
Remove the rear door from the loader hinges.
...