Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Chevrolet Tracker 1998-2004. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your Chevrolet Tracker like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Chevrolet Tracker 1998-2004 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2004 ENGINE Engine Mechanical - 2.5L (LE8) - Tracker
Engine Front Cover Replacement
Removal Procedure
1. Drain the engine oil.
2. Remove the throttle body and intake manifold. Refer to Intake Manifold Replacement.
3. Remove the power steering pump drive belt. Refer to Drive Belt Replacement - Air Conditioning Compressor and Power Steering.
4. Remove the water pump drive belt. Refer to Drive Belt Replacement - Cooling Fan and Generator.
5. Remove the left and right cylinder head covers. Refer to Camshaft Cover Replacement - Left and Camshaft Cover Replacement - Right.
6. Remove the cooling fan (3) and clutch (4). Refer to Fan Replacement in Engine Cooling.
7. Remove the water pump pulley (1).
8. Remove the radiator. Refer to Radiator Replacement in Engine Cooling.
9. Remove the thermostat cap. Refer to Thermostat Replacement (2.0L Engine) or Thermostat
Replacement (2.5L Engine) in Engine Cooling.
Fig. 56: View Of Cooling Fan, Clutch, Water Pump Pulley & Generator Drive Belt
10. Disconnect the connector (1) to the power steering pressure switch (2).
11. Remove the 3 bolts from the power steering pump and position out of the way.
12. Remove the 3 bolts from the power steering pump bracket and remove bracket.
13. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement.
14. Raise the vehicle.
15. Remove the front axle housing if equipped. Refer to Front Axle Housing Replacement in Front Drive
Axle.
16. Remove the lower oil pan. Refer to Oil Pan Replacement - Lower.
17. Remove the upper oil pan. Refer to Oil Pan Replacement - Upper.
18. Lower the vehicle.
Fig. 57: View Of Power Steering Pressure Switch & Connector
19. Disconnect the crankshaft position (CKP) sensor connector.
20. Remove the bolt and the crankshaft position (CKP) sensor.
21. Remove the bolts and the front cover (1).
Fig. 58: View Of Front Cover & Components
Installation Procedure
1. Clean the sealing surfaces on the front cover, the crankcase, the cylinder block and the cylinder heads.
2. Apply GM P/N 12346240 or equivalent to the front cover at the points indicated (1).
Fig. 59: Applying Sealant to Front Cover At Indicated Points
3. Apply engine oil to the oil seal lip (3) and the water pump O-ring (2).
NOTE: Refer to Fastener Notice in Cautions and Notices.
4. Install the front cover (1) and secure with the bolts.
Tighten: Tighten the bolts to 11 N.m (7.5 lb ft).
5. Apply engine oil to the O-ring of the crankshaft position (CKP) sensor.
6. Install the crankshaft position (CKP) sensor. Secure with the bolt.
...