Complete workshop service manual with electrical wiring diagrams for 1987-1996 Honda CBR600F1, CBR1000F Motorcycle. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

"'87-'90 CBR600F.pdf"
CBR600F (CBR600FG/CBR600FJ/CBR600FK/CBR600FL); 304 pages

"'87-'96 CBR600F1, CBR1000F Fours.pdf"
244 pages

"'92-'97 CBR600F1.pdf
497 pages

"Electrical Wiring Diagram.pdf"
4 pages

EXCERPT:

FUEL PUMP
INSPECTION
Turn the ignition switch ON and confirm that the fuel pump operates for a few seconds.
If the fuel pump does not operate, inspect as follows:
Open and support the front end of fuel tank (page 3-4).
Disconnect the fuel pump 3P (Black) connector.
Turn the ignition switch ON and measure the voltage between the terminals.
Connection: Brown (+) - Green (-)
There should be battery voltage for a few seconds.
If there is battery voltage, replace the fuel pump.
If there is no battery voltage, inspect the following:
- Main fuse 30A
- Sub fuse 10A
- Engine stop switch (page 19-19)
- Fuel cut relay (page 5-54)
- Engine stop relay (page 5-84)
- Bank angle sensor (page 5-83)
- ECM (page 5-85)
REMOVAL
NOTICE
• Before disconnecting the fuel tube, release the fuel pressure by loosening the service check bolt at the fuel tank.
• Always replace the sealing washers when the service check bolt is removed or loosened.
Remove the fuel tank (page 5-55).
Remove the fuel pump mounting nuts.
Remove the fuel pump assembly and packing.
FUEL FILTER REPLACEMENT
Disconnect the fuel tubes from the fuel filter. Remove the screws and fuel filter.
Install the fuel filter in the reverse order of removal.
Place a new packing onto the fuel tank.
Install the fuel pump being careful not to damage the fuel pump wire.
Install and tighten the fuel pump mounting nuts in the sequence shown.
TORQUE: 12 N*m (1.2 kgf-m)
FUEL CUT RELAY
INSPECTION
Remove the rear cowl (page 2-2).
Disconnect the fuel cut relay 4P connector, remove the fuel cut relay.
...