Complete workshop service manual with electrical wiring diagrams for 1984-2001 Honda Civic. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

1.78 GB PDF
├── '84-'87
├── '84-'95 Civic, CRX, Del Sol-.pdf
├── '84-'95 Civic, CRX, Del Sol.pdf
├── '84.pdf
├── '85 Supplement.pdf
├── '86-'87 Supplement.pdf
├── '87 Supplement.pdf
├── '87-'01 Civic (ES)
├── '87.pdf
├── '88 Civil Coupe CRX.pdf
├── '88-'92
├── '89 Supplement.pdf
├── '90 Civil Coupe CRX Supplement.pdf
├── '90 Supplement.pdf
├── '92 (US & Canada).pdf
├── '92-'95
├── '92-'95 (bonus).pdf
├── '92-'95.pdf
├── '92.pdf
├── '93 Supplement.pdf
├── '94 Supplement.pdf
├── '95
├── '95-'99
├── '96-'00.pdf
├── '96-'98.pdf
└── '98-'99

EXCERPT:
Evaporator
Replacement
1. Move the temperature control to "HOT."
'96-98: Slide the temperature control lever.
'99-00: Turn the ignition switch ON (II), then turn the temperature control knob. Turn the ignition switch off.
2. Remove the battery.
3. Recover the refrigerant with a recovery/recycling/charging station (see page 22-27).
4. Remove the bolts, then disconnect the suction and receiver lines from the evaporator.
NOTE: Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.
5. Remove the glove box (see section 20).
6. Remove the self-tapping screw and the passenger's dashboard lower cover. Remove the bolt, the nut
and the knee bolster, then remove the five bolts and the glove box frame.
7. Disconnect the connector from the A/C thermostat, and remove the wire harness from the evaporator.
Remove the four self-tapping screws, the mounting bolt and the mounting nut. Disconnect the drain hose, then remove the evaporator.
CONNECTOR
8. Install in the reverse order of removal. Make note of the following items.
• If you're installing a new evaporator, add refrigerant oil (SANDEN, SP-10 or DENSO, NO-OIL 8) (see page 22-22).
• Replace the 0-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them.
NOTE: Be sure to use the right 0-rings for HFC-134a (R-1348) to avoid leakage.
• Apply sealant to the grommets.
• Make sure that there is no air leakage.
• Charge the system (see page 22-46), and test its performance (see page 22-24).
...