Complete workshop & service manual with electrical wiring diagrams for Honda VTR250, VTR1000Fv, VTR1000F 1988-2003 Motorcycle. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Honda VTR250, VTR1000Fv, VTR1000F 1988-2003 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

├── '88-'90\ VTR250\ (aka\ Interceptor\ 250,\ MC33).pdf
├── '97-'00\ VTR1000Fv\ Firestorm\ (IT).pdf
├── '98-'03\ VTR1000F.pdf

EXCERPT:
CLUTCH/GEARSHIFT LINKAGE
CLUTCH SLAVE CYLINDER
DISASSEMBLY 9-10
Drain the clutch fluid from the hydraulic system (page 9-4).
Disconnect the clutch hose from the slave cylinder by removing the oil bolt and sealing washers.
CAUTION:
Avoid spilling clutch fluid on painted, plastic, or rubber parts. Place a rag over these parts whenever the system is serviced.
Remove the mounting bolts and slave cylinder.
Remove the gasket and dowel pins.
Remove the piston from the slave cylinder. If piston removal is hard, place a shop towel over the piston, position the cylinder body with the piston down and apply small squirts of air pressure to the fluid inlet.
Do not use high pressure air or bring the nozzle too close to the inlet.
Remove the spring, piston seal and oil seal from the piston.
INSPECTION
Check the piston spring for weakness or damage.
Check the slave cylinder and piston for scoring or damage.
…