Toyota FJ Cruiser 2005-2016 Workshop Repair & Service Manual

Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Toyota FJ Cruiser 2005-2016. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Toyota FJ Cruiser 2005-2016 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

560 MB, 3,231 pages, bookmarked, Searchable, Printable, high quality PDF

MAKE: Toyota
YEAR: 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016
MODEL: FJ Cruiser (GSJ10, GSJ15 Series)

EXCERPT:
1GR-FE ENGINE CONTROL SYSTEM – SFI SYSTEM ES–1
SFI SYSTEM - PRECAUTION
1. INITIALIZATION
NOTICE:
• Perform the RESET MEMORY (AT initialization) when replacing the automatic transmission
assembly, engine assembly or ECM (See page AT-19).
• Perform the REGISTRATION (VIN registration) when replacing the ECM (See page ES-15).
• If the ECM has been replaced or RESET MEMORY (AT initialization) has been performed, set up the function of the ATF (Automatic Transmission Fluid) temperature warning light (See page AT-19).
HINT: Initialization can not be completed by only removing the battery.
2. FOR USING INTELLIGENT TESTER
CAUTION: Observe the following items for safety reasons:
• Read its instruction books before using the tester.
• Prevent the tester cable from being caught on the
pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
• When driving the vehicle for testing purposes using the tester, two persons are required. One is for driving the vehicle, and the other operates the tester.
3. DISCONNECT AND RECONNECT CABLE OF NEGATIVE BATTERY TERMINAL
(a) Before performing electronic work, disconnect the cable from the negative (-) battery terminal in order to prevent it from shorting and burning out.
(b) Before disconnecting and reconnecting the battery cable, turn the ignition switch OFF and the headlight dimmer switch OFF. Then loosen the terminal nut completely. Do not damage the cable or terminal.
(c) When the battery cable is disconnected, the clock and radio settings and stored DTCs are erased. Therefore, before disconnecting the battery cable, make a notes of them.
NOTICE:
When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
DEFINITION OF TERMS
...