Complete workshop repair & service manual with electrical wiring diagrams for New Holland T8.275, T8.300, T8.330, T8.360, T8.390, T8.420 (CVT) Tractors. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This New Holland T8.275, T8.300, T8.330, T8.360, T8.390, T8.420 (CVT) Tractor service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

“47386189.pdf”
New Holland T8.275, T8.300, T8.330, T8.360, T8.390 Tractor Service Manual
PIN ZBRC07000 and after
4,263 pages, 340 MB
Part number 47386189; English
October 2012
…

“47533595.pdf”
New Holland T8.275, T8.300, T8.330, T8.360, T8.390, T8.420 (CVT) Tractor Service Manual
4,800 pages, 387 MB
PIN ZCRC02586 and above
Part number 47533595, 47533595S1 English
May 2013, December 2013
T8.275 [ZCRC02586 - ] , T8.300 [ZCRC02586 - ] , T8.330 [ZCRC02586 - ] , T8.360 [ZCRC02586 - ] , T8.390 [ZCRC02586 - ] , T8.420 [ZCRC02586 - ]
…

EXCERPT:
Transmission - Continuously Variable Transmission (CVT)
Cover Top cover with hydrostatic unit - Install
T8.275 [ZCRC02586 - ] WE, T8.300 [ZCRC02586 - ] WE, T8.330 [ZCRC02586 - ] WE, T8.360 [ZCRC02586 - ] WE, T8.390 [ZCRC02586 - ] WE
Prior operation:
Cover Top cover with hydrostatic unit - Assemble (21.504)
NOTE: Apply a bead of LOCTITE® 515 over the entire mounting surfaces and around all bolt holes and dowel holes.
1. Using proper lifting equipment, slowly lower the hydrostatic unit into place.
2. Install the eighteen cover mounting bolts and torque to 265 N·m (195.5 lb ft). Remove the lifting eyes.
3. Reinstall the oil cooler bypass valve mounting bracket (1) and secure with the bolts previously removed. Reconnect the hydrostatic motor lube line (2), making sure the brass washers are in place.
4. Reconnect the parking brake linkage.
5. Reinstall the steering lines and secure with the tube clamps (1) previously removed. Reconnect any other lines that may have been disconnected.
6. Lay the wire harness back into place on the harness bracket (1). Connect the connectors that were dis- connected and install wire ties (2) to secure the wire harness.
7. Reconnect the directional solenoid connectors.
8. Reconnect the connectors to the clutch solenoids (1) and the quad valve (2).
Next operation:
Cab - Install - Cab install (90.150)
…