Complete workshop & service manual with electrical wiring diagrams for Bobcat 324 Compact Excavator. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat 324 Compact Excavator service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

6989592 (1-10) - 324 Compact Excavator Operation & Maintenance Manual.pdf
6989593 (2-10) - 323 Compact Excavator Service Manual.pdf

EXCERPT:
CONTENTS
SAFETY & MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . 10-01
HYDRAULIC SYSTEM . . . . . . . . . . . . . . . . 20-01
UNDERCARRIAGE . . . . . . . . . . . . . . . . . . 30-01
UPPERSTRUCTURE & SWING . . . . . . . . . . . . . . . . . . . . 40-01
ELECTRICAL SYSTEM . . . . . . . . . . . . . . . 50-01
ENGINE . . . . . . . . . . . . . . . . . . . . . . . . . . . 60-01
SPECIFICATIONS . . . . . . . . . . . . . . . . SPEC-01
ALPHABETICAL INDEX . . . . . . . . . . . . . . . . . . . . . . . .INDEX-01
…
UPPERSTRUCTURE (CONT’D)
Installation
NOTE: Clean out the old excess Loctite® from all the 16 threaded holes in the slew bearing prior to installing the upperstructure.
Figure 40-10-5
Lower the upperstructure frame onto the swing bearing aligning the two pins (Item 1) [Figure 40-10-5]. Maintain
a slight amount of weight on the hoist.
Install the 16 bolts and washers through the upperstructure frame and into the swing bearing.
Tighten the bolts to 42 - 46.5 ft.-lb. (57 - 63 N•m) torque.
Install the swing motor. (See Removal And Installation on Page 20-90-1.)
Install the hydraulic control valve. (See Removal And Installation on Page 20-40-1.)
Install the control linkage assembly. (See Removal And Installation on Page 40-90-1.)
Install the floor mat and floor panels. (See Removal And Installation on Page 40-140-1.)
Install the seat and seat mount. (See Seat Mount Removal And Installation on Page 40-40-1.)
Fill the hydraulic reservoir. (See Checking And Adding Hydraulic Oil on Page 10-100-1.)
Install the battery. (See Removal And Installation on Page 50-20-2.)
Install the cab or canopy. (See Removal And Installation on Page 40-30-1.)
…