Complete workshop & service manual with electrical wiring diagrams for Bobcat 553 Skid-Steer Loader. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat 553 Skid-Steer Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

553 6724024 (11-95) - 553 Service Manual.pdf
553 6900450 (1-98) - 553 Service Manual.pdf
553 6901824 (3-06) - 553 Service Manual.pdf
553 6903125 (2-06) - 553 Service Manual.pdf
553 6904705 (3-06) - 553 Skid-Steer Loader Service Manual.pdf
6724696 (10-98) - 553 Operation & Maintenance Manual.pdf
6900385 (7-98) - 553 Operation & Maintenance Manual.pdf
6900785 (1-01) - 553 Operation & Maintenance Manual.pdf
6901823 (1-05) - 553 Operation & Maintenance Manual.pdf
6902827 (3-05) - 553 Operation & Maintenance Manual.pdf
6904701 (5-07) - 553 Skid-Steer Loader Operation & Maintenance Manual.pdf

EXCERPT:
CONTENTS
FOREWORD. . . . . . . II
SAFETY INSTRUCTIONS . . . . . . . . V
FIRE PREVENTION . . . . . . .VII
SERIAL NUMBER LOCATION . . . . IX
DELIVERY REPORT . . . . . .X
BOBCAT LOADER IDENTIFICATION . . . . . .XI
SAFETY AND MAINTENANCE. . . . . . . . 10-01
HYDRAULIC SYSTEM . . . . . . . . 20-01
HYDROSTATIC SYSTEM . . . . . . 30-01
DRIVE SYSTEM . . . . . . . 40-01
MAIN FRAME . . . . . . . . . 50-01
ELECTRICAL SYSTEM . . . . . . . 60-01
ENGINE SERVICE . . . . . 70-01
SPECIFICATIONS. . . . . . 70-01
…
STEERING (CONT’D)
Linkage Neutral Adjustment (Cont’d)
Figure 30-30-20
Loosen the two mounting bolts (Item 1) [Figure 30-30-20] on the adjustment bar for the rear pump pintle lever.
Move the left steering lever until the left side tires do not move (neutral position).
Figure 30-30-21
Move the adjustment bar (Item 1) [Figure 30-30-21] so it touches the bottom and top lobe (Item 2) [Figure 30-30-
21] of the pintle lever at the same time.
Be sure the wheels do not turn and stay in the neutral position.
Tighten the adjustment bar mounting bolts to 25-28 ft.-lbs. (34-38 Nm) torque.
Test the left steering lever by moving the lever forward and backward. Let the steering lever return to the neutral position.
If the wheels do not stop turning in neutral position, readjust the adjustment bar against the lobes of the pintle lever.
Repeat the procedure until the wheels stop turning (neutral position) and the steering lever is in the neutral
position.
After the left side linkage is complete, tighten the pivot bolts on the pintle lever and steering lever linkages.
Tighten the locknuts on each linkage to 25-28 ft.-lbs. (34-38 Nm) torque.
Repeat the complete procedure for the right side steering linkage.