Complete workshop & service manual with electrical wiring diagrams for Bobcat 741, 742, 743, 743DS, 742B, 743B Loader. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat 741, 742, 743, 743DS, 742B, 743B Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

6556858 (6-82) - 741 Operator's Manual.pdf
6556860 (5-97) - 742 Operation & Maintenance Manual.pdf
6556862 (4-96) - 743B Operation & Maintenance Manual.pdf
6566109 (4-88) - 741, 742, 743, 743DS Service Manual.pdf
6566338 (7-96) - 743DS Operation & Maintenance Manual.pdf
6566603 (3-83) - 741 Operator's Manual.pdf
6566604 (3-97) - 742 Operation & Maintenance Manual.pdf
6566605 (11-01) - 743 Operation & Maintenance Manual.pdf
6570166 (1-98) - 741, 742, 743, 743DS Operation & Maintenance Manual.pdf
6720180 (6-96) - 742 Operation & Maintenance Manual.pdf
6720613 (4-96) - 743B Operation & Maintenance Manual.pdf
6720737 (1-91) - 742B Operation & Maintenance Manual.pdf
6720772 (7-92) - 742B, 743B Service Manual.pdf
6722054 (8-97) - 743B Operation & Maintenance Manual.pdf
6722056 (2-99) - 742B Operation & Maintenance Manual.pdf

EXCERPT:
Removal And Installation (Cont’d)
Remove the grease fitting at the pivot pins [A].
NOTE: The grease fitting at the pivot pin must be removed, because the grease can cause a lock and the pivot pin cannot be removed from the Bob–Tach frame.
Put a rag over the grease fitting hole.
Hit the bolt to start the pivot pin into the Bob–Tach frame [B].
Remove the bolt and use a punch to push the pivot pin into the Bob–Tach frame.
Repeat the above procedure for the other side.
Installation: Use a small diameter punch through the grease fitting hole to push the pivot pin into the lift arms.
Remove the Bob–Tach from the lift arms.
Remove the Bob–Tach pivot pins [C].
Tilt Cylinder Rod End Seal
After the Bob–Tach is installed on the lift arms, use this procedure to install the rod end seals.
Lift the Bob–Tach with a floor jack [D].
…