Complete workshop repair service manual with electrical wiring diagrams for Bobcat T630 Compact Track Loaders. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat T630 Compact Track Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

6987163 (3-11) - T630 Compact Track Loader Operation & Maintenance Manual.pdf
6987163 (11-10) - T630 Compact Track Loader Operation & Maintenance Manual.pdf
6987164 (10-10) - T630 Compact Track Loader Service Manual.pdf
6987164 (12-13) - T630 Compact Track Loader Service Manual.pdf
6990751 (02-14) - T630 Compact Track Loader Service Manual.pdf

EXCERPT:
TABLE OF CONTENTS
SAFETY & MAINTENANCE . . . . . . 10-01
HYDRAULIC SYSTEM . . . 20-01
HYDROSTATIC SYSTEM . . . . . . . 30-01
DRIVE SYSTEM . . . . . . . . 40-01
MAINFRAME . . . 50-01
ELECTRICAL SYSTEM & ANALYSIS . . . . . 60-01
ENGINE SERVICE . . . . . . 70-01
HEATING, VENTILATION, AIR CONDITIONING . . . . 80-01
SPECIFICATIONS . . . SPEC-01
ALPHABETICAL INDEX . . . . . .INDEX-01
…
BOB-TACH (POWER)
Description
The Bob-Tach is the section of the loader lift arm that attachments mount to. The Power Bob-Tach option uses two hydraulically operated, spring assisted, locking wedge and lever assemblies to secure the attachment to the Bob-Tach.
The hydraulically operated Power Bob-Tach has a hydraulic cylinder that opens and closes both wedge and lever assemblies by pressing a switch on the right switch panel. The switch activates the Power Bob-Tach block to allow flow into or out of the hydraulic cylinder connected to the levers on the Bob-Tach.
The Power Bob-Tach block is located on the rear of the gear pump.
The Bob-Tach is located on the front of the loader connected to the loader lift arms.
Removal And Installation
Figure 50-41-1
Tilt the Bob-Tach forward, so it is parallel to the floor. Put 2x4 blocks under each side of the Bob-Tach [Figure 50-
41-1].
Lower the Bob-Tach onto the blocks.
Mark the hoses (Item 1) [Figure 50-41-1] for correct installation.
Remove and cap the hoses from the cylinder.
Remove the washers and bolts (Item 2) [Figure 50-41-1] from the cylinder (both ends).
Installation: Tighten the retainer nut to 48 - 54 N•m (35 - 40 ft-lb) torque.
Remove the cylinder from the Bob-Tach.
…