Complete workshop repair service manual with electrical wiring diagrams for Bobcat T650 Compact Track Loader. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat T650 Compact Track Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

6987171 (3-11) - T650 Compact Track Loader Operation & Maintenance Manual.pdf
6987171 (11-10) - T650 Compact Track Loader Operation & Maintenance Manual.pdf
6987172 (12-10) - T650 Compact Track Loader Service Manual.pdf

EXCERPT:
CONTENTS
SAFETY & MAINTENANCE . . . . . . . . . . . . 10-01
HYDRAULIC SYSTEM . . . . . . . 20-01
HYDROSTATIC SYSTEM . . . . 30-01
DRIVE SYSTEM . . . . . . . . . . . . 40-01
MAINFRAME . . . . . 50-01
ELECTRICAL SYSTEM & ANALYSIS . . . . 60-01
ENGINE SERVICE . . . . . . . . . . 70-01
HEATING, VENTILATION, AIR CONDITIONING . . . . . 80-01
SPECIFICATIONS . . . . . . . SPEC-01
ALPHABETICAL INDEX . . . . . . . . . . . .INDEX-01
…
HYDROSTATIC PUMP (SJC) (CONT'D)
Hydraulic Controller Removal And Installation
The loader’s right hand side hydraulic controller can be removed with the hydrostatic pump still in the loader. The loader’s left hand side hydraulic controller can only be removed when the hydrostatic pump is separated from the engine / hydrostatic pump cast mount.
Controller solenoids can be bled of trapped air in the controller. This should be performed when hydraulic controllers are replaced, removed or uncommanded oscillations in the controls are present.
Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.)
Place the loader on jackstands. (See Procedure on Page 10-10-1.)
…