Complete workshop & service manual with electrical wiring diagrams for Bobcat T750 Compact Track Loader. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat T750 Compact Track Loader service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

6989736 (3-11) - T750 Compact Track Loader Operation & Maintenance Manual.pdf
6989736 (12-10) - T750 Compact Track Loader Operation & Maintenance Manual.pdf
6989737 (4-11) - T750 Compact Track Loader Service Manual.pdf
6989737 (12-10) - T750 Compact Track Loader Service Manual.pdf

EXCERPT:
CONTENTS
SAFETY & MAINTENANCE . . . . 10-01
HYDRAULIC SYSTEM . . . . 20-01
HYDROSTATIC SYSTEM . . . . . 30-01
DRIVE SYSTEM . . . . . 40-01
MAINFRAME . . . 50-01
ELECTRICAL SYSTEM & ANALYSIS . . . . 60-01
ENGINE SERVICE . . . 70-01
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) . . . . . 80-01
SPECIFICATIONS . . . . SPEC-01
ALPHABETICAL INDEX . . . .INDEX-01
…
HYDROSTATIC DRIVE MOTOR (TWO SPEED)
Description
The hydrostatic drive motors are driven by the hydrostatic pump. Machines equipped with SJC are monitored by a sensor mounted onto the motor housing. The sensor is used for detection of motion and for rate of speed for the SJC option.
The hydrostatic drive motors contain a spring applied pressure release braking system. In addition there is a separate oil chamber in the motor that is filled with high performance synthetic oil for maximum durability, this oil has a recommended service interval. (See SERVICE SCHEDULE on Page 10-70-1.)
There are two hydrostatic drive motors and they are located on the track carriage.
Removing And Replacing Oil
For the correct service interval (See SERVICE SCHEDULE on Page 10-70-1.)
Park the loader so that the plug in the hydrostatic drive motor is at the bottom.
Remove the plug and let the oil drain from the hydrostatic drive motor.
Figure 30-21-1
Rotate the hydrostatic drive motor so that the plug (Item 1) [Figure 30-21-1] is vertical with the center of the hydrostatic drive motor. Add high performance synthetic oil (P/N 7003026). (See Capacities on Page SPEC-10-5.)
Clean the threads of the plug and drain hole. Apply Loctite 243 to the plug threads. Install and tighten the plug.
Repeat for the other hydrostatic drive motor.
Recycle or dispose of the used oil in an environmentally safe manner.
…