Complete workshop repair & service manual with electrical wiring diagrams for Ford Escape, Escape Hybrid, Mercury Mariner, Mariner Hybrid 2007. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Escape, Escape Hybrid, Mercury Mariner, Mariner Hybrid 2007 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· U02 — Ford Escape, XLS — 2-wheel drive
· U03 — Ford Escape, XLT — 2-wheel drive
· U04 — Ford Escape, Limited — 2-wheel drive
· U39 — Mercury Mariner, Hybrid — all-wheel drive
· U49 — Ford Escape, Hybrid — 2-wheel drive
· U59 — Ford Escape, Hybrid — 4-wheel drive
· U80 — Mercury Mariner, Convenience Version — 2-wheel drive
· U81 — Mercury Mariner, Luxury Version — 2-wheel drive
· U87 — Mercury Mariner, Premier Version — 2-wheel drive
· U90 — Mercury Mariner, Convenience Version — 4-wheel drive
· U91 — Mercury Mariner, Luxury Version — 4-wheel drive
· U92 — Ford Escape, XLS — 4-wheel drive
· U93 — Ford Escape, XLT — 4-wheel drive
· U94 — Ford Escape, Limited — 4-wheel drive
· U97 — Mercury Mariner, Premier Version — 4-wheel drive

· Z — 2.3L, 4-valve, in-line 4 cylinder
· 1 — 3.0L Modular, 6-cylinder, EFI, DOHC
· H — ATK-CYC, 2.3L, 4-valve PFI, in-line 4 cylinder, gas/electric (Hybrid)

EXCERPT:
2007 Escape/Mariner/Escape Hybrid/Mariner Hybrid
Workshop Manual
Alphabetical Index
1 A B C D E
F G H I J K
L M N O P Q
R S T U V W
Table of Contents
Introduction
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
Installation
CAUTION: Make sure the machined surfaces on the rear axle housing and the differential housing cover are clean and free of oil before installing the new silicone sealant. The inside of the rear axle must be covered when cleaning the machined surface to prevent contamination.
1. Clean the gasket mating surfaces of the differential housing and the differential housing cover.
NOTE: The differential housing cover must be installed within 15 minutes of application of the silicone, or new sealant must be applied. If possible, allow one hour before filling with lubricant to ∂make sure the silicone sealant has correctly cured.
Apply a new continuous bead of clear silicone rubber as shown in the illustration.
…