Complete workshop & service manual with electrical wiring diagrams for Ford Explorer 2011. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Explorer 2011 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

• K7B - Explorer, Front Wheel Drive (FWD)
• K7D - Explorer, Front Wheel Drive (FWD), XLT
• K7F - Explorer, Front Wheel Drive (FWD), Limited
• K8B - Explorer, All-Wheel Drive (AWD)
• K8D - Explorer, All-Wheel Drive (AWD), XLT
• K8F - Explorer, All-Wheel Drive (AWD) , Limited

• 8 - 3.5L, V6, gas

EXCERPT:
2011 Explorer
Workshop Manual
INTRODUCTION
Master DTC Chart
Diagnostic Methods
Metrics
Torque Wrench Adapter Formulas
1: GENERAL INFORMATION
00: SERVICE INFORMATION
2: CHASSIS
04: SUSPENSION
05: DRIVELINE
06: BRAKE SYSTEM
11: STEERING SYSTEM
3: POWERTRAIN
03: ENGINE
07: AUTOMATIC TRANSMISSION
08: MANUAL TRANSMISSION, CLUTCH, AND TRANSFER CASE
09: EXHAUST SYSTEM
10: FUEL SYSTEM
4: ELECTRICAL
12: CLIMATE CONTROL SYSTEM
13: INSTRUMENTATION AND WARNING SYSTEMS
14: BATTERY AND CHARGING SYSTEM
15: AUDIO SYSTEM
17: LIGHTING
18: ELECTRICAL DISTRIBUTION
19: ELECTRONIC FEATURE GROUP
5: BODY AND PAINT
01: BODY
02: FRAME AND MOUNTING
…
03: ENGINE
303-00 Engine System - General Information
303-01 Engine - 3.5L Ti-VCT
303-03 Engine Cooling
303-04 Fuel Charging and Controls - 3.5L Ti-VCT
303-05 Accessory Drive
303-06 Starting System
303-07 Engine Ignition - 3.5L Ti-VCT
303-08 Engine Emission Control
303-12 Intake Air Distribution and Filtering
303-13 Evaporative Emissions
303-14 Electronic Engine Controls
…
General Procedure
1. Add cooling system flush to the cooling system and follow the directions on the package.
2. Drain the cooling system. REFER to Cooling System Draining, Filling and Bleeding.
3. Remove the radiator. REFER to Radiator - 3.5L Ti-VCT.
4. NOTICE: Radiator internal pressure must not exceed 137.9 kPa (20 psi), or the radiator can be damaged Backflush the radiator with the radiator in an upside-down position with a high-pressure hose in the lower hose location and backflush.
5. Remove the thermostat. REFER to Thermostat - 3.5L Ti-VCT.
6. Position the high-pressure water hose into the engine through the upper radiator hose and backflush the engine.
7. Install the thermostat. REFER to Thermostat - 3.5L Ti-VCT.
8. Install the radiator. REFER to Radiator - 3.5L Ti-VCT.
9. Fill the cooling system. REFER to Cooling System Draining, Filling and Bleeding.
…