Complete workshop & service manual with electrical wiring diagrams for Ford Mustang 2005. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Mustang 2005 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· T80 — 2-door coupe, base
· T82 — 2-door coupe, GT
· T84 — 2-door convertible, base
· T85 — 2-door convertible, GT

· H — 4.6L, OHC, EFI, 8 cylinder
· N — 4.0L, SOHC, EFI, 6 cylinder

EXCERPT:
2005 Mustang
Workshop Manual
Alphabetical Index
A B C D E F
G H I J K L
M N O P Q R
S T U V W
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
Driveline Angle Inspection
Special Tool(s)
Anglemaster II Driveline Inclinometer
164-R2402 or equivalent
NOTE: An incorrect driveline angle can cause a vibration or shudder. For additional information, refer to Section 100-04 .
All vehicles
1. Check the vehicle for evidence of overload or sagging. Check for specified air pressures information in all 4 tires.
2. Normalize the suspension.
3. Drive the vehicle onto a drive-on hoist or back onto a front-end alignment rack.
4. Inspect the suspension and chassis. Verify that the vehicle curb position ride height is within specification. For additional information, refer to Section 204-00 .
· Measure the curb position ride height with the vehicle empty and all fluids full.
4.0L vehicles
5. Place the Inclinometer flush against the bottom of the driveshaft. After the tool has been held on the driveshaft surface for 5 seconds, push the ALT ZERO button to calibrate to zero degrees. Remove the tool.
6. To check the pinion angle, rotate the driveshaft so that the pinion flange yoke ear is parallel to the floor. Install the special tool. Check and record the pinion angle reading.
If the angle is not within specification, repair or adjust to obtain the correct angle. Inspect the rear suspension, axle, axle mounting or the frame for wear or damage.
…