Complete workshop & service manual with electrical wiring diagrams for Ford Mustang 2007. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Mustang 2007 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· T80 — 2-door coupe, base
· T82 — 2-door coupe, GT
· T84 — 2-door convertible, base
· T85 — 2-door convertible, GT
· T88 — 2-door coupe, Shelby
· T89 — 2-door convertible, Shelby

· H — 4.6L, OHC, 3-valve, EFI, 8-cylinder
· N — 4.0L, SOHC, EFI, 6-cylinder
· S — 5.4L, DOHC, 4-valve, EFI, 8-cylinder

EXCERPT:
2007 Mustang
Workshop Manual
Alphabetical Index
A B C D E F
G H I J K L
M N O P Q R
S T U V W
Table of Contents
Introduction
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
All vehicles
8. Remove the driveshaft. For additional information, refer to Section 205-01.
9. Disconnect the fuel vapor control tube assembly valve-to-fuel tank quick connect coupling. For additional information, refer to Section 310-00 .
10. Release the clamp and disconnect the fuel tank filler pipe hose-to-fuel tank.
· To install, tighten clamp to 3 Nm (27 lb-in).
11. Position a suitable lifting device under the fuel tank.
12. Remove the 2 fuel tank strap retaining bolts.
· To install, tighten to 53 Nm (39 lb-ft).
13. Position the emergency brake cables aside.
14. Remove the 2 fuel tank strap retainer pins and straps.
15. Partially lower the fuel tank enough to allow access to the fuel level sensor electrical connector.
16. Disconnect the fuel level sensor electrical connector.
17. Complete the lowering and removal of the fuel tank.
CAUTION: Make sure the fuel tubes are completely seated and that the quick connect couplings are locked correctly in place. Pull on the tube to make sure it is fully seated. Upon completion, pressurize the system and check for leaks.
To install, reverse the removal procedure.
…