Complete workshop & service manual with electrical wiring diagrams for Ford Ranger 2002. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Ranger 2002 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· R08 — 4x2, Regular cab (electric).
· R10 — 4x2, Regular cab.
· R11 — 4x4, Regular cab.
· R14 — 4x2, SuperCab (two-door).
· R15 — 4x4, SuperCab (two-door).
· R44 — 4x2, SuperCab (four-door)
· R45 — 4x4, SuperCab (four-door)

· D — 2.3L, EFI, four cylinder, gas.
· U — 3.0L, V6, gas.
· E — 4.0L, SOHC, V6, gas.
· 1 — 336V-75 HP electric (nickel metal hydride).
· 7 — 336V-75 HP electric (lead acid).

EXCERPT:
2002 Ranger
Workshop Manual
Alphabetical Index
A B C D E F
G H I J K L
M N O P R S
T U V W
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
Drive Pinion Flange and Drive Pinion Seal
Removal
1. Position the vehicle on a hoist. For additional information, refer to Section 100-02.
NOTE: The rear wheels and brake drums must be removed to prevent brake drag during drive pinion bearing preload adjustment.
2. Remove the wheel and tire assembly. For additional information, refer to Section 204-04.
3. Remove the rear brake drums. For additional information, refer to Section 206-02 .
4. Mark the driveshaft flange and pinion flange for correct alignment during installation.
…