Complete workshop & service manual with electrical wiring diagrams for Ford Tempo 1984-1994. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Tempo 1984-1994 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

EXCERPT:
ENGINE OVERHAUL
1994 FORD MOTOR CO. ENGINES 3.0L V6
ENGINE IDENTIFICATION
Engine may be identified by eighth character of Vehicle Identification Number (VIN), located on top of instrument panel, near lower left corner of windshield. VIN number is also stamped on Vehicle Certification (VC) label, mounted on left door pillar.
An engine identification label is located on engine. This label contains information for engine identification. An emission calibration number label is located on left door or pillar. Information from labels is required when ordering replacement parts.
ENGINE IDENTIFICATION CODES
…
Removal
1. Release fuel pressure and disconnect fuel lines. Refer to FUEL PRESSURE RELEASE & FUEL LINE CONNECTIONS under REMOVAL & INSTALLATION.
2. Remove battery and battery tray. Drain cooling system. Remove hood and air cleaner assembly.
Discharge A/C system using approved refrigerant recovery/recycling equipment.
3. Disconnect wiring harness connectors, coolant hoses, vacuum hoses and ventilation hoses. Disconnect ground straps at intake manifold. Disconnect hoses from power steering pump. Remove power steering reservoir.
4. Disconnect refrigerant line from condenser, leaving line attached to A/C compressor. Disconnect control cables at throttle body. Disconnect cruise control servo and secure aside.
5. On A/T equipped vehicles, disconnect electrical connectors, control cable, oil cooler lines and speedometer cable from transaxle.
6. On M/T equipped vehicles, remove clutch cable. Remove shift control rod and extension bar from transaxle. Disconnect electrical connections at transaxle.
7. On all vehicles, remove radiator hoses, cooling fan and shroud. Raise and support vehicle. Remove front wheels. Disconnect exhaust pipe at exhaust manifold. Remove power steering lines from rear of engine above transaxle. Remove lower radiator hose and starter.
8. Remove stabilizer bar from lower control arm. Remove nut and disconnect tie rod and lower ball joint from steering knuckle.
9. Pull outward on spindle assemblies to disengage axle shafts from transaxle. Install plugs in transaxle openings to hold differential gears in place.
10. Disconnect lower transaxle mount. Lower vehicle. Support engine with hoist. Disconnect engine and transaxle mounts. Lift engine and transaxle assembly from vehicle.
…