Complete workshop & service manual with electrical wiring diagrams for Ford/Mercury Cougar 2001. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford/Mercury Cougar 2001 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

VIN Code Line Series Additional Optional Exterior Nameplates Body Type Body Code
60 Cougar I4 - 3-door BC
61 Cougar V6 - 3-door BC
3 2.0 122 4 Gasoline Ford
L 2.5 153 6 Gasoline Ford
VIN Code Year
W 1998
X 1999
Y 2000
1 2001

EXCERPT:
2001 Cougar
Workshop Manual
Alphabetical Index
A B C D E F
G H I J K L
M N O P Q R
S T U V W
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
Special Testing Procedures
The special tests are designed to aid the technician in diagnosing the hydraulic and mechanical portion of the transaxle.
Engine Idle Speed Check
Refer to Powertrain Control/Emissions Diagnosis Manual for the engine idle speed adjustment procedure.
Line Pressure Test
The line pressure test verifies that the line pressure is within specifications.
CAUTION: Perform line pressure test before performing stall speed test. If line pressure is low at stall, do not carry out stall speed test or further transaxle damage will occur. Do not maintain WOT in any gear range for more than five seconds.
CAUTION: Transmission tester must be removed from the transaxle and the vehicle harness connected to verify these pressures.
1. Connect pressure gauge to line pressure tap.
Line Pressure Tap
2. Start engine and check line pressures. Refer to Line Pressure Chart 401 to determine if line pressure is within specifications.
3. If line pressure is not within specifications, perform on - board diagnostics and pinpoint test, air pressure check and repair main control system or pump as required.
…