Complete workshop & service manual with electrical wiring diagrams for Infiniti QX4 (R50) 1997-2003. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Infiniti QX4 (R50) 1997-2003 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

TABLE OF CONTENTS
QUICK REFERENCE INDEX
GENERAL INFORMATION
MAINTENANCE
ENGINE MECHANICAL
ENGINE LUBRICATION & COOLING SYSTEMS
ENGINE CONTROL SYSTEM
ACCELERATOR CONTROL, FUEL & EXHAUST SYSTEMS
CLUTCH
MANUAL TRANSAXLE
AUTOMATIC TRANSAXLE
FRONT AXLE & FRONT SUSPENSION
REAR AXLE & REAR SUSPENSION
BRAKE SYSTEM
STEERING SYSTEM
RESTRAINT SYSTEM
BODY & TRIM
HEATER & AIR CONDITIONER
ELECTRICAL SYSTEM
ALPHABETICAL INDEX

EXCERPT:
Rear Oil Seal and Companion Flange Oil Seal
Replacement
— 2WD MODEL —
NOTE:
Replace rear extension assembly as a single unit because it cannot be disassembled.
1. Remove propeller shaft. Refer to PD-5, “Components”.
2. Remove exhaust mounting and mounting bracket.
3. Disconnect revolution and speedometer sensor harness connector.
4. Support A/T assembly with a jack.
5. Remove rear engine mounting member. Tighten rear engine mounting member to the specified torque. Refer to EM-61, “Rear Engine Mounting”.
6. Remove rear extension assembly.
a. Remove parking gear and needle bearing.
CAUTION: Insert your hand between rear extension and transmission case. Detach rear extension assembly while holding parking gear and needle bearing by hand.
7. Reinstall any part removed.
Always use new sealing parts
…