Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2005-2016 Mazda5, 5 Grand Touring, 5 Sport, 5 Touring. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2005-2016 Mazda5, 5 Grand Touring, 5 Sport, 5 Touring is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2014 ENGINE Fuel System [MZR 2.5] - Mazda 5
FUEL LINE PRESSURE INSPECTION [MZR 2.5]
1. Complete the "BEFORE SERVICE PRECAUTION". (See BEFORE SERVICE PRECAUTION [MZR 2.5].)
2. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
4. Disconnect the quick release connector. (See QUICK RELEASE CONNECTOR REMOVAL /INSTALLATION [MZR 2.5].)
5. Turn the lever of the SST parallel to the hose as shown below.
6. Insert the SST quick release connector into the fuel pipe until a click is heard.
7. Verify that the quick release connector is firmly connected by pulling it by hand.
8. Start the fuel pump using the following procedure.
Using M-MDS
Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR
2.5] .)
Connect the M-MDS to the DLC-2.
Using the simulation function "FP", start the fuel pump. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.5] .)
Without using M-MDS
Remove the fuel pump relay.
...