Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2006-2014 Mercedes-Benz CL-Class (C216) CL65, CL65 AMG. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for 2006-2014 Mercedes-Benz CL-Class (C216) CL65, CL65 AMG is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
DRIVELINE/AXLES Rear Axle - 216.379 CL65 AMG
TESTING & REPAIR
LOCATE NOISES FROM REAR AXLE - AR35.00-P-2000A
MODEL all
Example shown on model 204
Fig. 1: Identifying Clamp Pliers With Microphone And Cable - Model 204
Fig. 2: Identifying Cable And Selection Switch - Model 211 Front Axle
Example shown on model 211 front axle
...
Removal
1. Place support (07) on workshop press.
2. Place front differential mount (8) on the support (07) and position.
See next picture:
The shoulder which is arched inwards (arrow) of the support (07) must abut the cutout (a) of the front differential mount (8).
Fig. 40: Removing Rubber Mount Of Front Center Assembly Mounting
3. Press rubber mounts (1) out of the front differential mount (8) using the thrust piece (06).
Install
Pay attention to the projection dimension when pressing in the rubber mounts (1). It is adjusted by using the measuring insert (08) when pressing in:
Right-hand projection dimension: 6.2 mm
Left-hand projection dimension: 8.7 mm
The measuring insert (08) has two different depth milled sections (see laser inscription). For the right rubber mount (1) the lettering 6.2 must face upwards, for the left rubber mount (1) the lettering 8.7.
4. Place support (07) on workshop press.
5. Insert measuring insert (08) in support (07).
Insert inscription on measuring insert (08).
Fig. 41: Installing Rubber Mount Of Front Center Assembly Mounting
6. Place front differential mount (8) on support and position. front differential mount (8).
7. Place rubber mounts (1) on the front differential mount (8) and move into the specified position. The notches (1k) must be twisted upwards by 15°.
8. Press rubber mounts (1) out of the front differential mount (8) using the thrust piece (06).
REMOVE/INSTALL FRONT DIFFERENTIAL MOUNT ON REAR AXLE CARRIER - AR35.10-P-
0051SZ
MODEL 221.054/056/070/071/077/084/086/087/095/176/177/179, 216.374/376/377/379
MODEL 221.128 with CODE (Z07) Top protection
...