Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Pontiac G6 2004-2010. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Pontiac G6 2004-2010 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2010 ENGINE Engine Mechanical - 3.5L - Repair Instructions - Off Vehicle - G6
VALVE ROCKER ARM AND PUSH ROD CLEANING AND INSPECTION
1. Clean the valve rocker arms and push rods in cleaning solvent.
2. Dry the valve rocker arms and push rods with compressed air.
WARNING: Refer to Cleaning Solvent Warning .
WARNING: Refer to Safety Glasses Warning .
Fig. 1: Identifying Valve Rocker Arm Inspection Areas
3. Inspect the valve rocker arms for the following conditions:
Excessive wear at the valve contact or push rod socket area (1)
# loose or damaged pin (2)
# worn or damaged roller bearing (3)-The roller should rotate freely with no binding or roughness.
# The bolt threads for damage
Fig. 2: Identifying Push Rod Inspection Areas
4. Inspect the push rods for the following conditions:
Straightness using a straight edge (1)
Excessive wear on the push rod ends (3)
Clogging of the oil passage (2)
CYLINDER HEAD DISASSEMBLE
SPECIAL TOOLS
EN-47823: Valve Spring Compressor Adapter
J 5892-D: Valve Spring Compressor
For equivalent regional tools, refer to Special Tools
DISASSEMBLY PROCEDURE
NOTE: Keep the push rods in order. The intake and exhaust are different lengths.
Fig. 3: View Of Heater Inlet Pipe Stud & Coolant Temperature Sensor
1. Remove the heater inlet pipe stud from the right cylinder head, if required.
2. Remove the coolant temperature sensor from the right cylinder head, if required.
...