Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Honda S2000 1999-2009. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Honda S2000 1999-2009 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2009 Honda S2000 CR
2000-09 ENGINE Engine Assembly - S2000
ENGINE REMOVAL
1. Remove the hood support rod from the driver's side of the car, then use it as shown below to fix the hood in a vertical position.
Fig. 1: Fixing Hood In Vertical Position
2. Make sure you have the anti-theft code for the radio, then write down the audio presets.
NOTE:
Use fender covers to avoid damaging painted surfaces.
To avoid damaging the wires and terminals, unplug the wiring connectors carefully while holding the connector portion.
Mark all wiring and hoses to avoid misconnection. Also, be sure that they do not contact other wiring or hoses, or interfere with other parts.
3. Relieve the fuel pressure:
2000-2005 models (see FUEL PRESSURE RELIEVING )
2006-2009 model (see FUEL PRESSURE RELIEVING )
4. Disconnect the negative cable from the battery first, then disconnect the positive cable.
5. Remove the battery.
6. Raise the vehicle on the hoist.
7. Drain the engine oil (see ENGINE OIL REPLACEMENT ).
8. Remove the transmission (see TRANSMISSION REMOVAL ).
9. Lower the vehicle on the hoist.
10. Disconnect the engine control module (ECM) connectors (A) from the ECM.
Fig. 2: Identifying Engine Control Module (ECM) Connectors
11. Disconnect the dashboard wire harness A connector(s) (B).
12. 2000-2005 models: Remove the vacuum tank.
Fig. 3: Identifying Vacuum Tank - 2000-2005 Models
13. 2000-2005 models: Remove the throttle cable (A) by loosening the locknut (B), then slipping the cable end out of the accelerator linkage. Take care not to bend the cable when removing it. Always replace any kinked cable with a new one.
Fig. 4: Identifying Throttle Cable - 2000-2005 Models
14. Remove the four bolts (A) securing the electrical power steering (EPS) control unit (B).
Fig. 5: Identifying Bolts Securing Electrical Power Steering (EPS) Control Unit
15. Remove the battery cable (A) from the main under-hood fuse/relay box, then remove the harness clamps (B).
...