Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Chevrolet Epica 2004–2011. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Chevrolet Epica 2004–2011 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2006 ENGINE Engine Mechanical - 2.5L (LBK) - Epica
ENGINE REPLACEMENT
Tools Required
J 28467-B , DW-117 (DW110-060) Universal Engine Support Fixture
J 39580 , (DW010-010) Power Pack Stand. See Special Tools.
Removal Procedure
Fig. 128: View Of Engine Cover And Nuts
1. Remove the fuel pump fuse.
2. Start the engine and repeat cranking until the remaining fuel in the fuel line is all consumed.
3. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
4. Drain the engine coolant. Refer to Draining and Filling Cooling System (2.5L) in Engine Cooling.
5. Drain the engine oil.
Fig. 129: View Of Air Filter Housing And Mounting Bolts
6. Drain the transaxle oil.
7. Drain the power steering oil.
8. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging in Heating, Ventilation, and
Air Conditioning.
9. Remove the engine beautification cover.
10. Remove the air filter snorkel.
11. Remove the air filter housing assembly.
Fig. 130: Locating Throttle Cable Release Slot
12. Remove the breather hose.
13. Disconnect the throttle cable from the throttle body assembly.
Fig. 131: View Of Coolant Reservoir And Mounting Bolts
14. Disconnect the coolant reservoir hoses.
15. Remove the coolant reservoir. Refer to Surge Tank Replacement (2.5L) in Engine Cooling.
Fig. 132: View Of Fuel Rail Components
16. Disconnect the power steering pump outlet pipe.
17. Disconnect the fuel rail hose and fuel feeding/return pipe.
Fig. 133: View Of ECT Sensor Connector
18. Disconnect the connectors on the following:
the O2S
EGR
charcoal canister purge solenoid valve
map sensor
throttle body
engine oil pressure sensor
CMP sensor
knock sensor
VIS
engine coolant temperature sensor
Fig. 134: View Of Support Bracket Wiring Harness
19. Detach the wiring harness from the wiring harness bracket on the cylinder block.
Fig. 135: Identifying Engine Block Ground And Bolts
20. Disconnect the engine block ground by removing the engine block ground bolts.
Fig. 136: View Of Battery And Mounting Nuts
21. Remove the battery.
22. Disconnect the automatic transaxle cable.
23. Disconnect the inhibit switch connector.
24. Disconnect the connectors on the transaxle.
...