Complete workshop repair service manual with electrical wiring diagrams for 1975-1989 Ferrari 308 GTB, 308 GTS, 328 GTB, 328 GTS. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

"Dino 308 GT4 Workshop Manual.pdf"
209 pages

"308 Quattrovalvole, 328 GTB_GTS Workshop Manual.pdf"
115 pages

"Dino 308 GT4 Technical Revisions Body.pdf"
29 pages

"Dino 308 GT4 Wiring Diagrams.pdf"
1 page

"328 GTB_GTS U.S. Version Wiring Diagrams 1989.pdf"
34 pages

"328 GTB_GTS U.S. Version Wiring Diagrams.pdf"
21 pages

"Dino 308 GT4 Spare Parts Catalogue.pdf"
182 pages

"308 QV Spare Parts Catalogue.pdf"
136 pages

"Fuel Pressure Test (308 GTBi_GTSi 1980-).pdf"
1 page

"Bosch KE3-Jetronic Injection System Manual (328 GTB_GTS & 3.2 Mondial).pdf"
94 pages

"328 GTB_GTS U.S. Version Technical Updates.pdf"
147 pages

"328 GTB_GTS U.S. Version Spare Parts Catalogue 1978.pdf"
150 pages

"328 GTB_GTS U.S. Version Owner’s Manual 1989.pdf"
103 pages

"328 GTB_GTS Spare Parts Catalogue 1988.pdf"
211 pages

"308 GTBi_GTSi Wiring Diagrams 1981.pdf"
17 pages

"308 GT4_GTB(I)_GTS(I) Service Time Schedule.pdf"
101 pages

EXCERPT:
Assemble Cylinder Liners and Crankshaft
- Carefully clean all parts, with particular attention to the oil galleries then place the engine block on the stand AV 617.
- The cylinder liners on the crankcase and ensure of the correct protrusion. Remove the
liners and install the rubber seal rings then definitively set the liners on the crankcase;
lock them with the clamps AS-6236 (see fig. 8).
- Rotate the crankcase and install the main hall bearings in their housings then lubricate them with normal engine oil.
- Place the crankshaft and the thrust hall rings on the crankcase; mount the caps with
relevant half bearings following the numeration printed inside the crankcase.
- Tighten the stud nuts to the prescribed driving torque indicated on the table on page M4.
- Now the crankshaft should turn without any effort freely and with adequate end float
(see page 811 ).
...

Ferrari 308 GTB/GTS, 328 GTB/GTS 1975-1989 Factory Service & Shop Manual