Complete workshop service manual with electrical wiring diagrams for 2004-2008 Honda CBR1000RR Fireblade Motorcycle. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This service & repair manual for CBR1000RR Fireblade (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

"'04-'05 CBR1000RR Fireblade.pdf"
586 pages

"'08 CBR1000RR Fireblade.pdf"
552 pages

EXCERPT:
ENGINE REMOVAL/INSTALLATION
Install the EOP switch wire clamp.
Route the EOP switch wire to the wire guide.
Connect the EOP switch wire terminal and tighten the bolt to the specified torque.
TORQUE: 2.0 N·m (0.2 kgf·m, 1.5 1bf.ft)
Install the dust cover.
Install the following:
- Direct ignition coils (page 4-1 0)
- PAIR control solenoid valve (page 6-78)
- Throttle body (page 6-62)
- Drive sprocket cover (page 4-28)
- Fuel tank (page 6-51)
- Radiator (page 7-19)
- Exhaust pipe (page 3-32)
- Middle cowls (page 3-10)
- Lower cowl (page 3-9)
Adjust the drive chain slack (page 4-26).
Fill the crankcase with the recommended oil (page 4-17).
Fill the cool ing system and bleed any air (page 7-7).
Check the clutch lever freeplay (page 4-34).
Check the exhaust system for leaks.
Check for coolant leaks.
...