Complete workshop & service manual with electrical wiring diagrams for Bobcat X225 Excavator. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Bobcat X225 Excavator service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

6720124 (11-89) - 220 Excavator Operation & Maintenance Manual.pdf
6720230 (5-89) - X220 Excavator Service Manual.pdf
6720230 (6-12) - X220 Excavator Service Manual.pdf
6720347 (6-12) - X 225 Excavator Service Manual.pdf
6720347 (11-89) - X 225 Excavator Service Manual.pdf
6720379 (11-89) - 220 Excavator Operation & Maintenance Manual.pdf
6720448 (4-92) - 220 Excavator Operation & Maintenance Manual.pdf
6720496 (4-90) - X 231 Excavator Service Manual.pdf
6720496 (6-12) - X 231 Excavator Service Manual.pdf
6720503 (6-12) - X220 Excavator Service Manual.pdf
6720503 (6-90) - X220 Excavator Service Manual.pdf
6720537 (9-98) - X 225 Excavator Operation & Maintenance Manual.pdf
6720874 (1-91) - X 225 Excavator Service Manual.pdf
6720874 (6-12) - X 225 Excavator Service Manual.pdf
6722178 (3-92) - X 231 Excavator Service Manual.pdf
6722178 (6-12) - X 231 Excavator Service Manual.pdf
6722250 (10-98) - X220 Excavator Operation & Maintenance Manual.pdf
6722345 (9-92) - 220 Excavator Service Manual.pdf

EXCERPT:
CONTENTS
SAFETY INSTRUCTIONS . . iv
SERIAL NUMBER LOCATIONS . . vi
DELIVERY REPORT . . . . . . vi
HYDRAULIC EXCAVATOR IDENTIFICATION . . . . . vii
PREVENTIVE MAINTENANCE . . . . . . 1–1
HYDRAULIC SYSTEM . . . . 2–1
DRIVE SYSTEM . . . . 3–1
UPPER WORKS & SWING SYSTEM . . . . . . 4–1
MAIN FRAME & TRACKS . . . . . . 5–1
ELECTRICAL SYSTEM . . . 6–1
ENGINE SERVICE . . 7–1
SPECIFICATIONS . . . 8–1
…
SWING GEAR BRAKE (NORDIC OPTION)
The swing motor brake is solenoid operated and is controlled by a push–pull knob (Item 1) [A] located on the top rear surface of the right control console.
Push knob down (normal position) to engage the brake.
Pull the knob up to disengage the brake.
Solenoid Removal and Installation
Lower the boom to the ground.
Stop the engine.
Remove the center floor panel. (See Page 5–2.)
Remove the swing motor cover. (See Page 5–3.)
Disconnect the wire harness from the solenoid [B].
Remove the solenoid (Item 1) [C] from the solenoid block (Item 2) [C].
NOTE: Replace the O–rings on the solenoid during installation.
…