Complete workshop & service manual with electrical wiring diagrams for Ford Taurus 2011. It's the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Ford Taurus 2011 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

· P2D - Taurus, Front Wheel Drive (FWD), SE
· P2E - Taurus, FWD , SEL
· P2F - Taurus, FWD , Limited
· P2H - Taurus, All-Wheel Drive (AWD), SEL
· P2J - Taurus, AWD , Limited
· P2K - Taurus, AWD , SHO

· T - 3.5L, DOHC, turbo-charged, 4 valve, V6
· W - 3.5L, DOHC, 4 valve, V6

EXCERPT:
2011 Taurus
Workshop Manual
Quick Links
Introduction
Master DTC Chart
Specifications
Metrics
Torque Wrench Adapter Formulas
Acronyms
Alphabetical Index
Table of Contents
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Audio Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body
02: Frame and Mounting
…
Installation
1. Lubricate the crankshaft front seal inner lip with clean engine oil.
NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.
Using the Front Cover Oil Seal Installer and Crankshaft Vibration Damper Replacer, install the crankshaft pulley.
2. Using the Strap Wrench, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
· Stage 1: Tighten to 120 Nm (89 lb-ft).
· Stage 2: Loosen one full turn.
· Stage 3: Tighten to 50 Nm (37 lb-ft).
· Stage 4: Tighten an additional 90 degrees.
3. Install the accessory drive belt and the power steering belt. For additional information, refer to Section 303-05.
…