Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Ford Edge 2007-2015. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Ford Edge 2007-2015 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
2014 ENGINE Fuel Tank & Lines - Edge, MKX
DESCRIPTION AND OPERATION
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
2. Release the fuel system pressure. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
3. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
4. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
5. Disconnect the vapor tube-to-EVAP canister purge valve quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
6. Disconnect the fuel tube-to-fuel injection pump quick connect coupling. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
7. Disconnect the fuel pressure sensor electrical connector.
8. Unclip the vapor tube and fuel supply tube from the brackets.
9. Disconnect the 2 middle-to-rear brake tube fittings.
To install, tighten to 20 Nm (177 lb-in).
10. Remove the 4 bolts, the 4 trim pins, the 2 push pins, and the Evaporative Emission (EVAP) shield.
To install, tighten to 10 Nm (89 lb-in).
11. Disconnect the EVAP vapor tube-to-EVAP canister quick connect coupling. For additional information,
refer to FUEL SYSTEM - GENERAL INFORMATION .
12. Disconnect the EVAP vapor tube assembly-to-EVAP canister quick connect coupling. For additional
information, refer to FUEL SYSTEM - GENERAL INFORMATION .
13. Remove the fresh air tube.
1. Disconnect the fresh air tube from the dust separator.
2. Release the retainer clip.
14. Remove the fuel tank. For additional information, refer to FUEL TANK .
15. Disconnect the middle brake tube fitting-to-rear brake hose.
To install, tighten to 18 Nm (159 lb-in).
14. Remove the fuel tank. For additional information, refer to FUEL TANK .
15. Disconnect the middle brake tube fitting-to-rear brake hose.
To install, tighten to 18 Nm (159 lb-in).
...